Synthrotek Ribbon Controller & Ribbon Touch Interface 3U(Demo)

The MST Ribbon module brings control to a whole new surface and fills out an already generous selection of modules designed by George Mattson. The Ribbon module pairs with Synthrotek’s Ribbon Controller Touch Interface modules that are available in various lengths in both 3U and 1U formats. Control Voltage, Gate and Pulse outputs allow for mega control over pitch, modulation, quantization, volume and more! Also connect your external signal into the EXT SIG IN jack to bypass the modules on-board voltage for passive external attenuation. Features: Exponential taper on RIB TRS input. Separate Gate and Pulse out. Pulse Out is ~1ms. External Signal Input. Reverse Polarity Protection Keyed 10 Pin Power Header Width: 4HP Depth: 20.6mm (0.811 in) Current Draw: +12v: 8mA -12v: 15mA +5v: N/A Comes With: Keyed Power Cable. 2.5mm and 3mm rack screws. Super cool sticker. Synthrotek’s Ribbon Controller Touch Interface is the perfect match for your MST Ribbon Controller Module. Connect your 3.5mm Stereo cable to the RIB IN jack and one of the jacks on the controller and you are off and flying. The Eurorack touch interfaces come in 3 sizes to fit your needs: 1U – 100mm, 1U – 200mm and 3U – 50mm. All controller modules have at least two jacks allowing you to change direction of use. Features: Minimum 2 TRS jacks for bi-directional use. 4 Form factors: 3U – 4HP 1U – 24HP 1U – 44HP Riblet Completely Passive. Depth: 12mm (0.47in) 1U Modules can be installed upside down for maximum compatibility with your rig. Comes with: 2.5mm and 3.0mm Rack screws. Super cool sticker.