Endorphin.es Grand Terminal (Yellow) - Synth Voice

• Dual 8 mode VCF / VCA, dual voltage controlled AD/AR/looping envelope, 16 algorithm stereo FX processor

  • Dual multi-mode filter (ladder, diode, vactrol, state-variable lp/hp/bp and comb) in dual, stereo and serial modes

  • Dual AD/ASR/looping envelope generator that acts as band-limited oscillator when cycling at linear slopes

  • Stereo “Cabin Pressure” processor with different 16 effects: from shimmered halls and reverberations to a spring simulation over tape/ping-pong delays / chorus / distortion / compressor and others.

  • Separate mono modular level output and stereo line level output for direct line recording or driving the headphones.

  • Easy firmware update via Audio.

  • Fully compatible with GatewayT_XP

  • Audio I/O: 48 kHz 16 bit, 32 bits internal processing

   

  Power consumption:

• 230 mA +12V

• 65 mA -12V

• 0 mA 5V

   

  Dimensions:

• 26 HP

• 26 mm deep

FAQ:

My Grand Terminal is behaving strangely. Can't change fx or vcf types. Signal is too low or distorted. Press all four knobs at once and hold them for more than 4 seconds. This is a soft reset and brings the module back to the factory settings.

I have small noise in my audio output in a certain cases? Try the following PSU adapter for your modular case: 15V Meanwell GST90A15

How to update. Check the video at Endorphin.es.

How can I replace the panel with other color? Check the merch store and panels replacement guide. Also don’t forget the knobs and buttons.

Rainbow cable pinout. Side red/brown pair of pins always correspond to -12V similar as with typical gray ribbon cable.